897341 O-ring - Porter Cable

O-rings are made to contain thousands of PSI pressure by creating a seal between two or more parts. O-ring measurements are specified by the inside diameter and the thickness. Of the many causes for O-Ring failure, the most common among power tools are: Extrusion and Nibbling – O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny “bites” from the o-ring, or caused by clearance gaps. Abrasion – One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. Over Compression – O-ring is flattened on both sides and may have a “ring” split along its length. Commonly caused by excessive pressure or heat. Heat Hardening – O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity. Weather/Ozone Cracking – O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.