161346-0 Oil Pump Cpl., Ea3201s - Makita

$64.00
In Stock
SKU
161346-0
Authorized Dealer OEM
×

Know Before You Order

"This chainsaw oil pump is sold individually. It measures approximately 2.5-Inches wide and 1.5-Inches high. The oil pump drives bar oil from the oil tank to the bar. The oil lubricates the bar and chain to avoid wear and heat. To inspect your oil pump, remove the bar and chain from your saw and start the engine. You should notice oil moving from the oiler location. It is common for saw dust and debris to plug the oiler, so check to see if the opening is clear. Also inspect the opening in the bar to ensure it is not clogged. If the oiler is clean and no oil is flowing, this likely means the pump is bad and needs to be replaced. For this repair, you will begin by removing the side cover, the chain, and the bar. Then remove the retaining clip and the outer washer. Use a screwdriver to gently loosen the retaining clip off the crankshaft. Be mindful not to misplace the retaining clip as it comes loose. Remove the clutch drum from the crankshaft. With that removed, now pull off the inner washer. You will then need to remove the brake assembly. Make sure it is in the lock position, so the spring does not have any tension on it."
More Information
On OfferNo
Buy TogetherNo
Ship FreeNo
Write Your Own Review
You're reviewing:161346-0 Oil Pump Cpl., Ea3201s - Makita
© Copyright 2026. MMToolParts.com All Rights Reserved.